Spudgun.com LED specification page


 

1. 5mm led light spec:

Voltage - 4.8Vdc
Current draw - 150Mah (all 5 lights)
LED color  intensity:
.5W, 5mm, RED - 75,000 mcd, 60 deg
.5W, 5mm, Green - 80,000 mcd, 60 deg
.5W, 5mm high intensity white 100,000 mcd, 60 deg
5mm Red flash- 10,000 mcd, 60 deg
5mm, White flash, 20,000 mcd, 60 deg
Wire lead length - 48"

2. 8mm LED light spec:

Voltage - 4.8Vdc
Current draw - 250mah
LED color intensity:
2, 1W, 8mm, White - 230,000 mcd (950 lumens) ea, 140 deg
1, 1W, 8mm Red - 200,000mcd (830 lumens), 140 deg
1, 1W, 8mm Green - 220,000 mcd (910 lumens), 140 deg
1, 5mm Red flashing, 10,000 mcd (41 lumens), 60 deg
1, 5mm White flashing, 20,000 mcd (83 lumens), 60 deg
2, 7mm clear frenzel lenses for 5mm LED's
Wire lead length- 48"

3. 10mm Led light spec:

Voltage - 4.8Vdc
Current draw - 250mah
2, 1W, 10mm White - 380,000mcd, 40 deg
1, 1W, 10mm Red - 280,000 mcd, 40 deg
1, 1W, 10mm Green - 400,000 mcd, 40 deg
1, 5mm Red flashing, 10,000 mcd (41 lumens), 60 deg
1, 5mm White flashing, 20,000 mcd (83 lumens), 60 deg
2, 7mm clear frenzel lenses for 5mm LED's.
Wire lead length 48"

4. 10mm LED landing lights:

1, 1W, 10mm high intensity LED, 380,000mcd (320 lumens),  40deg
Wire lead length, 48"

Strobe module spec:  

Strobe module will flash LED's at a 50% on/off rate.

Duty rate 50%
Time on - .25 sec.
time off - .25 sec
Logic voltage - 3 to 18Vdc.
Logic current draw - .002mah.
Max switching voltage - 30Vdc.
Max switching current - 5A
Weight - .25oz

RC servo switch module:

Module will allow you to turn on/off LED light, remote ignition, retracts, rocket ignition, audio devices and much more
by using any unused channel on your receiver.

Specs: Max switching voltage - 30Vdc
Max switched current  - 5A
Logic voltage - 3 to 18vdc
Weight - .25oz

UBEC module:

This device will allow you to use the above LED's Nav lights on any voltage up to 30V. It will regulate the voltage down to the 5.0Vdc needed to operate the LED's.

Spec:
Input - 5 - 30Vdc
Output - 5vdc, 3A continuous
Weight - 13g

LED strips:

 Each led strip comes with adhesive backing. Can be broken down into 3 LED segments. Operating voltage is 10 - 12Vdc. Each 3 LED segment has solder tabs so you can wire different colors in series or parallel.