90 day warranty against defective workmanship
www.spudgun.com/led.htm
IF YOU ARE USING THE POWER FROM YOUR RECEIVER FOR THE LEDS AND STROBE MODULE
Strobe module instructions
for use with receiver voltage.
You will need a “Y” connector to isolate the blinking strobe LED’s from the other landing and marker lights. Follow the schematic above and pay special attention to the color of the wires used on the “Y” connector. The RED and BLACK wires are the output of the open receiver channel.. Remember LED’s operate on 5 - 6Vdc ONLY.
www.spudgun.com/led.htm V.1
Strobe module instructions
for use with RC servo switch.
You will need a “Y” connector to isolate the blinking strobe LED’s from the other landing and marker lights. Follow the schematic above and pay special attention to the color of the wires used on the “Y” connector. The RED and WHITE wires are the switched output of the RC servo switch. If you are not using a RC servo switch then use the red and black wires. Remember LED’s operate on 5Vdc ONLY.
www.spudgun.com/led.htm V.1